New Posts New Posts RSS Feed - How to add air to water pressure tank?
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedHow to add air to water pressure tank?

 Post Reply Post Reply
Author
Chris62 View Drop Down
Newbie
Newbie


Joined: 13-Jan-2001
Location: PA
Points: 1
Direct Link To This Post Topic: How to add air to water pressure tank?
    Posted: 06-Dec-2001 at 1:01am
It's an Air Guard 42 gal. 75lb. max. psi tank. Once a year, the previous owner said he would have to add air to the tank. Could someone offer some direction on the proper procedure for doing this?
Specifically;
The Schroeder fitting...should I check the pressure here before I do anything? What should it read? There is a gauge in the line where the water enters the house from the well but, before it enters the tank. As water is turned on, this gauge holds at about 45-46 psi. and the device just above this gauge seems to cycle about every 4-5 seconds as well as the actual flow of water.

If I need to add air, which valves need to be turned off? (There's a water filter in the line).
Do I have to completely drain the system?
Can I add air with a foot pump type of "compressor"?
How much pressure should the bladder have?
Why is it losing air?
I appreciate all the help I can get.
Thank you
Chris

Back to Top
fourth year View Drop Down
Newbie
Newbie


Joined: 19-Jan-2002
Points: 21
Direct Link To This Post Posted: 08-Dec-2001 at 4:02am
You have to turn off the supply valve to the system and drain all the water from the tank. Drain all the water you can out of the tank by opening a faucet and letting it run until it stops. Then check the air pressure in the tank. If it is zero, then all the water may not be out of the tank so leave the faucet open while you add air. Pump it up to about 5 pounds less than the pump's turn on point so that the tank is still pressurized when the pump starts.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down